The seat belt control ECU receives collision information from the driving support ECU and skid control ECU via CAN communication and tightens the seat belt by operating the motor inside the front seat outer belt RH.
When DTC B2000 is stored, DTCs B2016, B2026, B2027 and B2035 are not stored.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2000 | During the initial check or with the ignition switch ON, the seat belt motor RH circuit has a power supply short (the voltage at terminals MOR+ and MOR- is 8.5 V or higher) for 1 second or more. | ·
Front seat outer belt assembly RH ·
Harness or connector ·
Seat belt control ECU |
The pretensioner is built into the front seat outer belt assembly RH. Be sure to follow the correct inspection procedure, as failure to follow the correct procedure (such as inspection of incorrect connectors) may activate the pretensioner.
Disconnect the G117 ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G117-2 (MOR+) - Body ground | Ignition switch ON | Below 1 V |
| G117-1 (MOR-) - Body ground |
| *a | Front view of wire harness connector
(to Seat Belt Control ECU) |
OK
NG
Disconnect the Q3 belt connector.
Disconnect the G117 ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| Q3-1 (MOR+) - Body ground | Ignition switch ON | Below 1 V |
| Q3-2 (MOR-) - Body ground |
| *a | Front view of wire harness connector
(to Front Seat Outer Belt Assembly RH) |
OK
NG