Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY (for 5 Door) › 2015.06–2017.08
RM27T0E _58 Vehicle Interior _053738 SEAT BELT _0261148 FRONT SEAT OUTER BELT ASSEMBLY(for 5 Door) A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY(for 5 Door)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 28800 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 62312B 3.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

a.

Partially remove the front door opening trim weatherstrip so that the lower center pillar garnish and center pillar garnish can be removed (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL).


Hide 58371F 4.REMOVE REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)

Hide 67934 5.REMOVE QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)

Hide 62332C 7.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

a.

Partially remove the rear door opening trim weatherstrip so that the lower center pillar garnish and center pillar garnish can be removed (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL).


Hide 62414A 9.REMOVE LOWER CENTER PILLAR GARNISH LH

a.
B238736

Remove the bolt and disconnect the front seat outer belt floor anchor.


b.
B238737

Detach the 4 claws and 2 clips and remove the lower center pillar garnish.


Hide 73220 13.REMOVE FRONT SEAT OUTER BELT ASSEMBLY

B241717

a.

Remove the nut and shoulder anchor.


b.
B239044E02
0.49,1.104 0.667,1.313 0.177,0.208 10 true B 2.333,0.24 2.51,0.438 0.177,0.198 10 false A

Disconnect the pretensioner connector labeled A as shown in the illustration.


c.

w/ Pre-Crash Safety System:

Disconnect the pre-crash safety connector labeled B.


d.
B239045

Remove the bolt and seat belt.


Hide 73024 14.REMOVE FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY

B245778

a.

Remove the 2 bolts and remove the anchor plate.