This DTC is stored when a malfunction in the brake system is detected. This circuit consists of the skid control ECU and seat belt control ECU. Signals are sent from the skid control ECU to the seat belt control ECU through the CAN communication line.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2060 | While the initial check is running, the ignition switch is ON and the pre-crash safety system is operating, a brake system malfunction signal is received from the skid control ECU for 1 second. | ·
Vehicle stability control system ·
Seat belt control ECU |
Check for DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>DTC CHECK / CLEAR).
Vehicle stability control system DTCs are not output.
OK
NG
Clear the DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
DTC B2060 is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG