The seat belt control ECU is connected to the main body ECU through CAN communication.
The seat belt control ECU receives the steering wheel position information from the main body ECU via CAN communication and stores the vehicle model information. If the seat belt control ECU cannot receive the steering wheel position information from the main body ECU, DTC B2064 is stored.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2064 | During the initial check, the steering wheel position information sent to the seat belt control ECU from the main body ECU stops for 3 seconds or more. | ·
CAN communication system ·
Main body ECU (Multiplex network body ECU) ·
Seat belt control ECU |
Select "Bus Check" from the "System Select" screen on the intelligent tester.
Select "Communication Malfunction DTC" from the "Bus Check" screen, and then select "Enter".
| Result | Proceed to |
|---|---|
| CAN DTC is not output | A |
| CAN DTC is output (for LHD with Entry and Start System) | B |
| CAN DTC is output (for LHD without Entry and Start System) | C |
| CAN DTC is output (for RHD with Entry and Start System) | D |
| CAN DTC is output (for RHD without Entry and Start System) | E |
A
B
C
D
E
Clear the DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
DTC B2064 is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Replace the seat belt control ECU (See page Vehicle Interior>PRE-CRASH SAFETY>SEAT BELT CONTROL ECU>REMOVAL).
NEXT
Clear the DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
DTC B2064 is not output.
OK
NG