The seat belt control ECU receives driver side buckle switch condition information from the center airbag sensor assembly through the CAN communication line and controls the pre-crash safety system.
This code is stored when a buckle switch malfunction signal is received from the airbag system.
When DTC B2074 is stored, DTC B1655/37 is also stored.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2074 | While the initial check is running, the ignition switch is ON and the pre-crash safety system is operating, malfunction a signal is received from the center airbag sensor for 3 seconds. | ·
Airbag system ·
Seat belt control ECU |
Check for DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
DTC B1655/37 is not output.
OK
NG
(See pageVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
Clear the DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
DTC B2074 is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG