Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2015.06–2017.08
RM27T0E _58 Vehicle Interior _053736 PRE-CRASH SAFETY _0261101 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  C1A02  Vehicle Information Not Obtained  


DESCRIPTION

When the driving support ECU is replaced with a new one, it acquires the country specification information from the main body ECU (multiplex network body ECU). If the driving support ECU cannot store the country specification information, DTC C1A02 is stored.

DTC Code DTC Detection Condition Trouble Area
C1A02 While the ignition switch is ON and the pre-crash safety system is operating, the driving support ECU cannot store the country specification information.
·

Main body ECU (Multiplex network body ECU)

·

Driving support ECU



PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
a.

Use the Data List to check if the country specification information is correct (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DATA LIST / ACTIVE TEST).

Pre-Crash 2
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Country# (DSS) Driving support ECU country signal / JPN, NA, EURO, AUS, SAFC, OTHER, TWN, CHINA, THAI, GCC or NOFIX EURO, AUS, TWN, THAI or GCC -

OK:

Country specification information is correct.




OK

2.CHECK FOR DTC

NG

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND DRIVING SUPPORT ECU