Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
67910
1.REMOVE DOOR SCUFF PLATE ASSEMBLY RH
Put protective tape around the door scuff plate.
Using a screwdriver, detach the 4 clips, 10 claws and 2 guides and remove the door scuff plate.
Tape the screwdriver tip before use.
| *1 | Protective Tape |
62111C
2.REMOVE COWL SIDE TRIM BOARD RH
Remove the clip.
Detach the clip and claw and remove the cowl side trim board.
55317A
3.REMOVE INSTRUMENT SIDE PANEL RH
55461A
4.REMOVE INSTRUMENT PANEL ORNAMENT
55607
5.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55550
6.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
87201B
7.REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY
82877
8.REMOVE ECU INTEGRATION BOX RH
88150A
9.REMOVE DRIVING SUPPORT ECU ASSEMBLY
Detach the claw and remove the driving support ECU assembly.