The driving support ECU uses the millimeter wave radar sensor assembly to detect obstacles in front of the vehicle.
Based on this information, the driving support ECU sends pre-crash control operation signals.
When the driving support ECU receives information that there is a malfunction in the millimeter wave radar sensor assembly, DTC C1A10 is stored.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1A10 | While the ignition switch ON, the driving support ECU receives information that there is a malfunction in the millimeter wave radar sensor for 1 second. | ·
Millimeter waver radar sensor assembly ·
Driving support ECU |
Replace the millimeter wave radar sensor assembly (See page Engine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>REMOVAL).
NEXT
Adjust the millimeter wave radar sensor assembly (See page Engine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT).
NEXT
Clear the DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
DTC C1A10 is not output.
OK
NG