After performing this inspection, be sure to perform initialization (initial position reset and initial position memorization) of the fold seat control ECU (See page Vehicle Interior>SEAT>REAR POWER SEAT CONTROL SYSTEM>INITIALIZATION).
79304A
1.INSPECT NO. 3 SEATBACK FRAME SUB-ASSEMBLY LH
Check the operation of the seatback frame.
Apply battery voltage to the power seat motor, and check that the seatback moves smoothly as follows.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 3
Battery negative (-) → 4 |
Front |
| Battery positive (+) → 4
Battery negative (-) → 3 |
Rear |
If the result is not as specified, replace the No. 3 seatback frame LH.
| *a | Component without harness connected
(No. 3 Seatback Frame LH) |
|
Front |
|
Rear |
79303A
2.INSPECT NO. 3 SEATBACK FRAME SUB-ASSEMBLY RH
Check the operation of the seatback frame.
Apply battery voltage to the power seat motor, and check that the seatback moves smoothly as follows.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 3
Battery negative (-) → 4 |
Front |
| Battery positive (+) → 4
Battery negative (-) → 3 |
Rear |
If the result is not as specified, replace the No. 3 seatback frame RH.
| *a | Component without harness connected
(No. 3 Seatback Frame RH) |
|
Front |
|
Rear |
79040
3.INSPECT NO. 3 SEAT LEG ASSEMBLY LH
Check the operation of the seat leg.
Apply battery voltage to the power seat motor, and check that the seat leg arm moves smoothly as follows.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 3
Battery negative (-) → 4 |
Front |
| Battery positive (+) → 4
Battery negative (-) → 3 |
Rear |
If the result is not as specified, replace the No. 3 seat leg assembly.
| *1 | Seat Leg Arm |
| *a | Component without harness connected
(No. 3 Seat Leg Assembly LH) |
|
Front |
|
Rear |
79020B
4.INSPECT NO. 2 SEAT LEG ASSEMBLY (for RH Side)
Check the operation of the seat leg.
Apply battery voltage to the power seat motor, and check that the seat leg arm moves smoothly as follows.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 3
Battery negative (-) → 4 |
Front |
| Battery positive (+) → 4
Battery negative (-) → 3 |
Rear |
If the result is not as specified, replace the No. 2 seat leg assembly.
| *1 | Seat Leg Arm |
| *a | Component without harness connected
(No. 2 Seat Leg Assembly) |
|
Front |
|
Rear |