Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
73230
1.INSTALL FRONT SEAT INNER BELT ASSEMBLY RH (for Bench Seat Type)
Pass the front seat inner belt assembly RH through the band of the front seat cushion cover as shown in the illustration.
Install the front seat inner belt assembly RH to the front seat assembly RH with the nut.
Make sure that the protruding part of the front seat inner belt assembly RH is not positioned on top of the frame.
| *a | Protruding Part |
Attach the 3 wire harness clamps and connect the occupant detection sensor connector.
Install the front seat assembly RH (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Bench Seat Type)>INSTALLATION).
73240
2.INSTALL FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)
Install the front seat belt anchor plate.
Install the front seat inner belt assembly LH to the front seat assembly LH with the nut.
Do not allow the anchor part of the front seat inner belt assembly LH to overlap the protruding parts of the front seat adjuster.
| *a | Protruding Part |
Connect the connector and attach the 4 clamps.
73230
3.INSTALL FRONT SEAT INNER BELT ASSEMBLY RH (for Passenger Side)
Install the front seat belt anchor plate.
Install the front seat inner belt assembly RH to the front seat assembly RH with the nut.
Do not allow the anchor part of the front seat inner belt assembly RH to overlap the protruding parts of the front seat adjuster.
for Manual Seat, Power Seat 4 Way Seat Type:
Connect the 2 connectors and attach the 3 clamps.
for Power Seat 8 Way Seat Type:
Connect the 2 connectors and attach the 6 clamps.
4.INSTALL FRONT SEAT ASSEMBLY LH
for Manual Seat:
Install the front seat assembly LH (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>INSTALLATION).
for Power Seat:
Install the front seat assembly LH (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>INSTALLATION).