Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
73380C
1.INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY RH
Install the inner belt with the bolt.
Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding part of the front seat adjuster.
| *a | Protruding Part |
71825B
2.INSTALL REAR SEAT CUSHION MOULDING RH
3.INSTALL REAR SEAT ASSEMBLY RH
Install the rear seat assembly RH (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type RH Side)>INSTALLATION).