Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
73370C
1.INSTALL REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
When installing the retractor, make sure the claws of the vehicle (labeled "a" in the illustration) only contact the installation areas of the retractor.
Align the seat belt positioning holes with the claws and install the retractor of the seat belt with the 2 bolts as shown in the illustration.
First install bolt A, and then install bolt B.
Install the rear No. 1 seat outer belt shoulder anchor with the bolt.
62640P
2.INSTALL REAR QUARTER TRIM PANEL ASSEMBLY LH
64740C
3.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
Attach the 9 claws and 11 clips to install the deck trim side panel.
Install the 3 bolts and 2 screws.
Install the rear No. 1 seat outer belt floor anchor with the bolt.
Install the front seat outer belt floor anchor with the bolt.
73233
4.INSTALL OUTER LAP BELT ANCHOR COVER
64712F
5.INSTALL FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)
64937A
6.INSTALL NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)
64725D
7.INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
58570C
8.INSTALL REAR FLOOR CARPET ASSEMBLY
62538C
9.INSTALL QUARTER TRIM COVER HOLE LH
58574A
10.INSTALL REAR FLOOR MAT REAR SUPPORT PLATE
58649C
11.INSTALL MAT SET PLATE COVER
64910M
12.INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)