Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
72123A
1.REMOVE FRONT OUTER SEAT TRACK BRACKET COVER RH
72127A
2.REMOVE FRONT INNER SEAT TRACK BRACKET COVER RH
72137B
3.REMOVE SEAT TRACK COVER RH
72157A
4.REMOVE INNER SEAT TRACK BRACKET COVER RH
73101A
5.REMOVE FRONT SEAT LAP OUTER BELT SUB-ASSEMBLY
Remove the bolt and disconnect the front seat lap outer belt sub-assembly from the floor.
Remove the front seat assembly RH.
In order to perform work under the seat, it is not necessary to remove the seat from the cabin. Simply tilt the seat backward.
Remove the 2 bolts.
Operate the seat track adjusting handle and move the seat to the rearmost position.
Remove the 2 bolts.
Disconnect the connector and detach the wire harness clamp from under the seat.
Tilt the front seat assembly RH backward while being careful not to damage the vehicle interior or wire harnesses with the seat frame.
Pass the front seat lap outer belt sub-assembly through the band of the front seat inner belt assembly RH and remove it by pulling it up through the seat.
| *1 | Band of Front Seat Inner Belt Assembly RH |