Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
62985A
1.REMOVE ROOF SIDE AIR OUTLET REGISTER (w/ Rear Air Conditioning System)
Use the same procedure for all roof side air outlet registers.
Detach 6 claws and remove the roof side air outlet register.
63341
2.REMOVE NO. 1 ROOF SILENCER PAD (w/o Sliding Roof)
Remove the 2 No. 1 roof silencer pads.
63342
3.REMOVE NO. 2 ROOF SILENCER PAD (w/o Sliding Roof)
Remove the No. 2 roof silencer pad.
63343
4.REMOVE NO. 3 ROOF SILENCER PAD
Remove the No. 3 roof silencer pad.
63344
5.REMOVE NO. 4 ROOF SILENCER PAD (w/o Sliding Roof)
Remove the No. 4 roof silencer pad.
81340J
6.REMOVE VANITY LIGHT ASSEMBLY LH
Detach the 2 claws labeled A and separate the bulb holder from the vanity light as shown in the illustration.
Detach the claw labeled B and remove the vanity light.
| *1 | Claw A |
| *2 | Claw B |
| *3 | Bulb Holder |
81340H
7.REMOVE VANITY LIGHT ASSEMBLY RH
Use the same procedure described for the LH side.
82171
8.REMOVE NO. 1 ROOF WIRE
Turn the visor connectors approximately 90° clockwise and remove them from the roof headlining.
Detach each clamp and remove the No. 1 roof wire.
Remove any butyl tape remaining on the roof headlining.
| *A | w/o Sliding Roof | *B | w/ Sliding Roof |
| *C | w/ Rear Seat Entertainment System | *D | w/ Rain Sensor, for LHD |
| *E | w/ EC Mirror | *F | w/ Rain Sensor, for RHD |
| *1 | Visor Connector | - | - |
86101J
9.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY