Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR (for Front Door) › 2015.06–2020.08
RM27T0E _59 Vehicle Exterior _053742 WINDOW / GLASS _0261232 POWER WINDOW REGULATOR MOTOR(for Front Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Front Door)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 67492A 2.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Hide 69298A 3.REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH

Hide 74611C 4.REMOVE ASSIST GRIP COVER LH

Hide 67602 5.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 68172A 6.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

Hide 86160 7.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

Hide 67832 8.REMOVE FRONT DOOR SERVICE HOLE COVER LH

Hide 68102 9.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

Hide 69802 10.REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

Hide 85720C 11.REMOVE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

a.

Using a T25 "TORX" socket wrench, remove the 3 screws and the power window regulator motor.

B412033E01
5.406,0 5.826,0.290 0.420,0.290 10 *a 5.851,2.228 6.271,2.519 0.420,0.290 10 *1 5.523,1.813 5.827,2.223 false

Text in Illustration
*1 Spring - -
*a Range of Movement - -

CAUTION:

Do not place your finger, etc. within the range of movement of the window regulator. When removing the power window regulator motor, the force of the spring causes the window regulator to move in the direction of the arrow shown in the illustration (the direction in which the window rises), which may cause injury. NOTICE: Be careful when removing the screws as the motor may fall and become damaged.