Use the same procedure for the LH and RH sides.
The procedure listed below is for the LH side.
63310
1.REMOVE ROOF HEADLINING ASSEMBLY
Remove the roof headlining (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL).
62432B
2.REMOVE NO. 1 ROOF SIDE RAIL GARNISH LH
Detach the 3 clips.
Cut off clip A.
Remove the roof side rail garnish.
Remove clip A from the vehicle body.
| *1 | Clip A |
62720A
3.REMOVE QUARTER WINDOW ASSEMBLY LH
Apply protective tape to the outer surface of the vehicle body to prevent scratches.
When separating the quarter window glass from the vehicle, be careful not to damage the vehicle paint or interior/exterior ornaments.
From the interior, insert a piano wire between the vehicle body and quarter window glass as shown in the illustration.
| *1 | Protective Tape |
| *2 | Piano Wire |
Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.
Cut through the adhesive by pulling the piano wire around the quarter window glass.
Leave as much adhesive on the vehicle body as possible when removing the quarter window glass.
| *1 | Piano Wire |
| *2 | Wooden Blocks |
| *3 | Protective Tape |
Using suction cups, remove the quarter window glass.
4.CLEAN VEHICLE BODY
Clean and shape the contact surface of the vehicle body.
| *1 | Adhesive |
| *2 | Vehicle Body |
On the contact surface of the vehicle body, use a knife to cut away excess adhesive as shown in the illustration.
Leave as much adhesive on the vehicle body as possible.
Be careful not to damage the vehicle body.
Clean the contact surface of the vehicle body with cleaner.
Even if all the adhesive has been removed, clean the vehicle body.