Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM › 2015.06–2017.08
RM27T0E _59 Vehicle Exterior _053747 LIGHTING (EXT) _0261275 LIGHTING SYSTEM J

LIGHTING (EXT)  LIGHTING SYSTEM  Front Fog Light Circuit  


DESCRIPTION

The main body ECU receives headlight dimmer switch information signals and illuminates the front fog lights.

WIRING DIAGRAM

E199765E02
5.444,2.862 5.595,3.018 0.152,0.156 10 A 5.444,3.019 7.123,3.386 1.680,0.367 10 Main Body ECU (Multiplex Network Body ECU) 5.842,1.238 6.053,1.408 0.211,0.170 10 13 6.164,1.333 6.584,1.503 0.420,0.170 10 FFGO 5.842,0.769 6.053,0.938 0.211,0.170 10 14 6.164,0.864 6.584,1.034 0.420,0.170 10 TRLY 4.897,2.035 5.488,2.205 0.591,0.170 10 FR FOG 3.879,2.419 4.470,2.589 0.591,0.170 10 FOG FR 3.344,1.583 3.699,1.753 0.355,0.170 10 TAIL 4.184,1.469 4.539,1.638 0.355,0.170 10 TAIL 0.508,0.834 1.377,1.036 0.869,0.202 10 from Battery 0.132,1.78 1.404,1.964 1.272,0.184 10 to Front Fog Lights 2.16,0.856 2.374,1.016 0.214,0.161 10 2K 2.2,0.668 2.334,0.838 0.134,0.170 10 1 2.16,1.789 2.374,1.950 0.214,0.161 10 2F 2.2,1.602 2.334,1.771 0.134,0.170 10 9 2.833,2.821 5.211,3.005 2.378,0.184 10 Driver Side Junction Block Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (FRONT FOG LIGHT RELAY)
a.

Using the intelligent tester, perform the Active Test (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DATA LIST / ACTIVE TEST).

Main Body
Tester Display Test Part Control Range Diagnostic Note
Front Fog Light Relay Front fog light relay ON/OFF The headlight dimmer switch is in the tail position.

OK:

Front fog light relay operates (front fog lights come on).




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
2.CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
a.

Remove the driver side junction block with its connectors still connected (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).


b.
U116503E04
0.188,0.073 0.365,0.24 0.177,0.167 10 false *a 1.604,0.354 1.833,0.531 0.229,0.177 10 false 2F

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
2F-9 - Body ground Headlight dimmer switch in tail and front fog light switch on 11 to 14 V


Text in Illustration
*a Component with harness connected
(Driver Side Junction Block Assembly)



OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (DRIVER SIDE JUNCTION BLOCK ASSEMBLY - FOG LIGHT ASSEMBLY)

NG

3.INSPECT DRIVER SIDE JUNCTION BLOCK ASSEMBLY
3.INSPECT DRIVER SIDE JUNCTION BLOCK ASSEMBLY
a.
U170738E02
1.635,3.333 1.823,3.5 0.188,0.167 10 false A 1.677,1.625 1.865,1.792 0.188,0.167 10 false 2F 1.677,0.26 1.885,0.427 0.208,0.167 10 false 2K

Remove the driver side junction block assembly (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).


b.

Remove the main body ECU from the driver side junction block assembly (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
2F-9 - Body ground Apply battery positive (+) to 2K-1, and battery negative (-) to A-13 and A-14 11 to 14 V
Always Below 1 V




OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY