The main body ECU receives headlight dimmer switch information signals and illuminates the rear fog lights.
Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.
Using the intelligent tester, perform the Active Test (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DATA LIST / ACTIVE TEST).
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Rear Fog Light Relay | Rear fog light relay | ON/OFF | The headlight dimmer switch is in the tail position. |
Rear fog light relay operates (rear fog lights come on).
OK
NG
Remove the rear fog light relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied between terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied between terminals 1 and 2 | Below 1 Ω |
OK
NG
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Rear fog light relay terminal 5 - Body ground | Always | 11 to 14 V |
| Rear fog light relay terminal 2 - Body ground | Headlight dimmer switch off | Below 1 V |
| Headlight dimmer switch tail | 11 to 14 V |
| *a | Front view of wire harness connector
(to Rear Fog Light Relay) |
OK
NG
Remove the main body ECU (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Rear fog light relay terminal 1 - A-27 (RFGO) | Always | Below 1 Ω |
| A-27 (RFGO) - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the driver side junction block assembly (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).
Remove the main body ECU from the driver side junction block assembly (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2F-19 - A-27 | Always | Below 1 Ω |
OK
NG