Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
81560
1.INSTALL REAR COMBINATION LIGHT ASSEMBLY LH
Put protective tape around the rear combination light assembly LH.
| *1 | Protective Tape |
Connect the connector.
Move the rear combination light assembly LH in the direction of the arrow in the illustration and attach the 4 clips to install the rear combination light assembly LH.
Install the 2 bolts.
| *A | for LH Side | *B | for RH Side |
52159
2.INSTALL REAR BUMPER COVER