Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
55606
1.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
84340
2.REMOVE STOP LIGHT SWITCH ASSEMBLY
Disconnect the connector.
Turn the stop light switch assembly counterclockwise and remove the stop light switch assembly.
84345
3.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
Using a screwdriver, detach the 2 claws and remove the stop light switch mounting adjuster.
Tape the screwdriver tip before use.
| *1 | Tape |