Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
75722A
1.INSTALL REAR DOOR BELT MOULDING LH
Attach the 7 claws to install the rear door belt moulding.
68104
2.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
68124B
3.INSTALL REAR DOOR QUARTER WINDOW GLASS LH
67408E
4.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
68152C
5.INSTALL REAR DOOR GLASS RUN LH
67842E
6.INSTALL REAR DOOR SERVICE HOLE COVER LH
68174A
7.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH
67604
8.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
74611C
9.INSTALL ASSIST GRIP COVER LH
69298C
10.INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH
11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).