The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN and multiplex communication system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Refer to the How to Troubleshoot ECU Controlled Systems in Introduction section.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Refer to DTC Check/Clear.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Refer to Check Mode Procedure.
| Proceed to |
|---|
| NEXT |
NEXT
Refer to Road Test.
| Result | Proceed to |
|---|---|
| Symptom does not occur | A |
| Symptom occurs | B |
A
B
Refer to Symptom Simulation.
| Proceed to |
|---|
| NEXT |
NEXT
Refer to DTC Check/Clear.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Refer to Park/Neutral Position Switch Assembly.
Click hereDrivetrain>AC60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>PARK / NEUTRAL POSITION SWITCH>INSPECTION
Refer to Shift Lever Assembly.
Click hereDrivetrain>AC60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>SHIFT LEVER>COMPONENTS
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to Mechanical System Tests.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to Hydraulic Test.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to Manual Shifting Test.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to Problem Symptoms Table.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to Problem Symptoms Table.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Refer to Diagnostic Trouble Code Chart.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT