Home › Vehicle Interior › SEAT › FRONT POWER SEAT CONTROL SYSTEM (w/ Memory) › 2015.06–2017.08
RM27T0E _58 Vehicle Interior _053737 SEAT _0261110 FRONT POWER SEAT CONTROL SYSTEM(w/ Memory) Y

SEAT  FRONT POWER SEAT CONTROL SYSTEM(w/ Memory)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedures to troubleshoot the front power seat control system.

·

*: Use the intelligent tester.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result:
Proceed to
NEXT



NEXT

3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
a.

for LHD with Entry and Start System:

i.

Use the intelligent tester to check if the CAN communication system is functioning normally.

(See pagePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD with Entry and Start System)>DIAGNOSIS SYSTEM).



b.

for LHD without Entry and Start System:

i.

Use the intelligent tester to check if the CAN communication system is functioning normally.

(See pagePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD without Entry and Start System)>DIAGNOSIS SYSTEM).



c.

for RHD with Entry and Start System:

i.

Use the intelligent tester to check if the CAN communication system is functioning normally

(See pagePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD with Entry and Start System)>DIAGNOSIS SYSTEM).



d.

for RHD without Entry and Start System:

i.

Use the intelligent tester to check if the CAN communication system is functioning normally.

(See pagePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD without Entry and Start System)>DIAGNOSIS SYSTEM).



Result:
Result Proceed to
CAN DTC is not output A
CAN DTC is output (for LHD with Entry and Start System) B
CAN DTC is output (for LHD without Entry and Start System) C
CAN DTC is output (for RHD with Entry and Start System) D
CAN DTC is output (for RHD without Entry and Start System) E



A

4.CHECK DTC OUTPUT*

B

C

D

E

4.CHECK DTC OUTPUT*

A

5.PROBLEM SYMPTOMS TABLE

B

7.ADJUST, REPAIR OR REPLACE
5.PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in problem symptoms table A
Fault is listed in problem symptoms table B



A

6.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

7.ADJUST, REPAIR OR REPLACE
6.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

7.ADJUST, REPAIR OR REPLACE
7.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

8.CONFIRMATION TEST
8.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END