Use these procedures to troubleshoot the glass hatch opener system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Check if the CAN communication system is functioning normally
for LHD with Entry and Start system:
for LHD without Entry and Start system:
for RHD with Entry and Start system:
for RHD without Entry and Start system:
| Result | Proceed to |
|---|---|
| No DTCs output | A |
| DTCs are output (for LHD with Entry and Start system) | B |
| DTCs are output (for LHD without Entry and Start system) | C |
| DTCs are output (for RHD with Entry and Start system) | D |
| DTCs are output (for RHD without Entry and Start system) | E |
A
B
C
D
E
Refer to the Problem Symptoms Table.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>PROBLEM SYMPTOMS TABLE
| Proceed to |
|---|
| Fault is not listed in problem symptoms table |
| Fault is listed in problem symptoms table |
Fault is not listed in problem symptoms table
Fault is listed in problem symptoms table
Operation Check
Click hereVehicle Exterior>WINDOW / GLASS>GLASS HATCH OPENER SYSTEM>OPERATION CHECK
Terminals of ECU
Click hereVehicle Exterior>WINDOW / GLASS>GLASS HATCH OPENER SYSTEM>TERMINALS OF ECU
Data List / Active Test
Click hereVehicle Exterior>WINDOW / GLASS>GLASS HATCH OPENER SYSTEM>DATA LIST / ACTIVE TEST
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT