Use the following procedures to troubleshoot the steering lock system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs and make a note of any codes that are output.
Click hereSteering>STEERING COLUMN>STEERING LOCK SYSTEM>DTC CHECK / CLEAR
Clear the DTCs.
Click hereSteering>STEERING COLUMN>STEERING LOCK SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs. Based on the DTCs output above, try to cause the output of the same wireless door lock control system DTC, LIN communication system DTC, steering lock system DTC, engine immobiliser system DTC or entry and start system (for entry function) DTC by reproducing the symptoms indicated by the DTC.
Click hereSteering>STEERING COLUMN>STEERING LOCK SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| Wireless door lock control system DTC is output. | B |
| LIN communication system DTC is output. | C |
| Steering lock system DTC is output. | D |
| Engine immobiliser system DTC isoutput. | E |
| Entry and start system (for entryfunction) DTC is output. | F |
A
B
C
D
E
F
Refer to Problem Symptoms Table.
Click hereSteering>STEERING COLUMN>STEERING LOCK SYSTEM>PROBLEM SYMPTOMS TABLE
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
A
B
Terminals of ECU
Click hereSteering>STEERING COLUMN>STEERING LOCK SYSTEM>DATA LIST / ACTIVE TEST
Data List / Active Test
Click hereSteering>STEERING COLUMN>STEERING LOCK SYSTEM>TERMINALS OF ECU
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT