Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM › 2015.06–2017.08
RM27T0E _58 Vehicle Interior _053731 THEFT DETERRENT / KEYLESS ENTRY _0261054 THEFT DETERRENT SYSTEM Y

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use this procedure to troubleshoot the theft deterrent system.

·

*: Use the intelligent tester.

·

The troubleshooting procedures for the theft deterrent system are based on the premise that the door lock control system, wireless door lock control system, lighting system, horn system, engine immobiliser system and entry and start system (w/ Entry and Start System) are operating normally. Check these systems first before troubleshooting the theft deterrent system.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

Result:
Proceed to
NEXT



NEXT

3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
a.

Use the intelligent tester to check if the CAN communication system is functioning normally.


Result:
Result Proceed to
CAN DTC is not output A
CAN DTC is output (for LHD with Entry and Start System) B
CAN DTC is output (for LHD without Entry and Start System) C
CAN DTC is output (for RHD with Entry and Start System) D
CAN DTC is output (for RHD without Entry and Start System) E



A

4.CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*

B

C

D

E

4.CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*
a.

The theft deterrent system uses the LIN communication system to communicate. Check that the LIN communication system is functioning normally.


Result:
Result Proceed to
LIN communication system is normal A
LIN communication system is malfunctioning B



A

5.CHECK FOR DTC*

B

5.CHECK FOR DTC*
a.

Check for DTCs and note any codes that are output.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>DTC CHECK / CLEAR



c.

Based on the DTCs output above, try to force output of the same DTC by simulating the symptoms indicated by the DTC. Then recheck for DTCs.

Click here


Result:
Result Proceed to
DTC output does not reoccur A
DTC output reoccurs B



A

6.PROBLEM SYMPTOMS TABLE

B

8.REPAIR OR REPLACE
6.PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in problem symptoms table A
Fault is listed in problem symptoms table B



A

7.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

8.REPAIR OR REPLACE
7.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

8.REPAIR OR REPLACE
8.REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

9.CONFIRMATION TEST
9.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END