Use the following procedures to troubleshoot the key reminder warning system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
Use the intelligent tester to check if the CAN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| CAN DTC is not output | A |
| CAN DTC is output (for LHD without Entry and Start System) | B |
| CAN DTC is output (for RHD without Entry and Start System) | C |
A
B
C
Refer to the Problem Symptoms Table.
Click hereVehicle Interior>DOOR LOCK>KEY REMINDER WARNING SYSTEM>PROBLEM SYMPTOMS TABLE
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
A
B
Operation Check.
Click hereVehicle Interior>DOOR LOCK>KEY REMINDER WARNING SYSTEM>OPERATION CHECK
Terminals of ECU.
Click hereVehicle Interior>DOOR LOCK>KEY REMINDER WARNING SYSTEM>TERMINALS OF ECU
Data List/Active Test.
Click hereVehicle Interior>DOOR LOCK>KEY REMINDER WARNING SYSTEM>DATA LIST / ACTIVE TEST
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT