| Detection Item | Symptom | Trouble Area |
|---|---|---|
| DCM Communication Stop Mode | Either Condition is met:
·
"DCM" is not displayed on "Bus Check". ·
"DCM Communication Stop Mode" in "DTC Combination Table" applies. |
·
Power source or inside telematics transceiver ·
Telematics transceiver branch wire or connector ·
Telematics transceiver |
Inspect the fuses for circuits related to this system before performing the following procedure.
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and the CAN branch wire.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the airbag system.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
NEXT
Disconnect the G187 telematics transceiver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G187-15 (CANP) - G187-16 (CANN) | Ignition switch off | 54 to 69 Ω |
| *a | Front view of wire harness connector
(to Telematics Transceiver) |
OK
NG
Connect the cable to the negative (-) battery terminal.
When connecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G187-4 (E) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G187-1 (+B) - Body ground | Always | 11 to 14 V |
| G187-7 (IG2) - Body ground | Ignition switch ON | 11 to 14 V |
| G187-8 (ACC) - Body ground | Ignition switch ACC | 11 to 14 V |
| *a | Front view of wire harness connector
(to Telematics Transceiver) |
OK
NG