Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS TRANSCEIVER › 2016.08–2020.08
RM27T0E _56 Audio / Visual / Telematics _056796 TELEMATICS _0280234 TELEMATICS TRANSCEIVER A

TELEMATICS  TELEMATICS TRANSCEIVER  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



Hide 67910 2.REMOVE DOOR SCUFF PLATE ASSEMBLY RH

Hide 62111C 3.REMOVE COWL SIDE TRIM BOARD RH

Hide 55317A 4.REMOVE INSTRUMENT SIDE PANEL RH

Hide 55607 5.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55461A 6.REMOVE INSTRUMENT PANEL ORNAMENT

Hide 55550 7.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 85970A 8.REMOVE DOUBLE LOCK DOOR CONTROL RELAY ASSEMBLY (w/ Double Locking System)

Hide 86741A 9.REMOVE TELEMATICS TRANSCEIVER

a.
E348929

Remove the bolt, nut and telematics transceiver from the vehicle.


b.

Disconnect each connector.


Hide 86705 10.REMOVE TELEPHONE ANTENNA CORD SUB-ASSEMBLY

a.
E348930

Disconnect each connector.


b.

Detach the 4 clamps and remove the telephone antenna cord sub-assembly.