Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
73200A
1.INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
Align the claw with the anchor plate positioning hole, and install the front shoulder belt anchor adjuster assembly with the 2 bolts.
First install the lower bolt, and then install the upper bolt.
73220
2.INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH
When installing the retractor, make sure the 2 claws of the vehicle (labeled "a" in the illustration) only contact the installation areas of the retractor.
Align the seat belt retractor positioning holes with the 2 claws of the vehicle.
Install the front seat outer belt assembly LH with the bolt.
Connect the pretensioner connector as shown in the illustration.
Install the shoulder anchor of the front seat outer belt assembly LH with the nut.
62412
3.INSTALL CENTER PILLAR GARNISH LH
74611G
4.INSTALL NO. 2 ASSIST GRIP
74638
5.INSTALL NO. 2 ASSIST GRIP PLUG LH
62414A
6.INSTALL LOWER CENTER PILLAR GARNISH LH
Attach the 4 claws and 2 clips to install the lower center pillar garnish LH.
Install the floor anchor of the front seat outer belt assembly LH with the bolt.
73233
7.INSTALL OUTER LAP BELT ANCHOR COVER
62332C
8.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
67918D
9.INSTALL REAR DOOR SCUFF PLATE LH
67934
10.INSTALL INSIDE QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)
58371F
11.INSTALL REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)
62312B
12.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
67920
13.INSTALL DOOR SCUFF PLATE ASSEMBLY LH
14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
15.CHECK SRS WARNING LIGHT
Check the SRS warning light (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).