51450
1.REMOVE REAR ENGINE UNDER COVER ASSEMBLY
2.DRAIN ENGINE OIL
3.REMOVE WIRING HARNESS CLAMP BRACKET (w/ Urea SCR System)
Detach the 3 clamps to disconnect the wire harness.
Remove the bolt and wiring harness clamp bracket.
12102A
4.REMOVE NO. 2 OIL PAN SUB-ASSEMBLY
89491
5.REMOVE ENGINE OIL LEVEL SENSOR
Disconnect the engine oil level sensor connector.
Remove the clip from the engine oil level sensor.
Remove the 2 nuts and 2 stud bolts, remove the oil level sensor bracket.
Detach the clamp and remove the 2 bolts from the engine oil level sensor.