Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY › from 2017.08
RM27T0E _59 Vehicle Exterior _053747 LIGHTING (EXT) _0261279 REAR COMBINATION LIGHT ASSEMBLY A

LIGHTING (EXT)  REAR COMBINATION LIGHT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 81560 1.INSTALL REAR COMBINATION LIGHT ASSEMBLY LH

a.

Connect the connector.


b.
E375409C01
1.354,2.563 1.552,2.729 0.198,0.167 10 true *a 1.917,1.354 2.115,1.542 0.198,0.188 10 true *b 1.156,2.042 1.354,2.208 0.198,0.167 10 true *c 1.979,2.198 2.177,2.385 0.198,0.188 10 true *b
*a Wire Harness Clamp
*b Pin
*c Guide


Set the rear combination light assembly LH towards the vehicle front to attach the guide, 2 pins and clip.


c.

Attach the wire harness clamp.


d.

Install the 2 bolts.


Hide 52159 2.INSTALL REAR BUMPER COVER