The No. 1 headlight ECU sub-assembly LH stores this DTC if the sensor value received from the height control sensor is out of range when performing initialization of the No. 1 headlight ECU sub-assembly LH; for example, the vehicle is not level or being jacked up.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B2452 | Height Control Sensor Data Out of Range When Initializing | Rear height control sensor sub-assembly LH value is out of range when initializing | ·
Vehicle condition when initializing ·
No. 1 headlight ECU sub-assembly LH |
w/o Air Suspension System |
If the No. 1 headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the No. 1 headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (for LED Headlight)>REGISTRATION
Perform initialization of the No. 1 headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (for LED Headlight)>REGISTRATION
Before initializing the No. 1 headlight ECU sub-assembly LH, make sure that the vehicle condition is proper for initialization.
Be sure to perform initialization as instructed.
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch to ON.
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (for LED Headlight)>DTC CHECK / CLEAR
DTC B2452 is not output.
If the No. 1 headlight ECU sub-assembly LH stores DTC B2452 even though the ECU has been initialized as instructed, there may be a malfunction in the No. 1 headlight ECU sub-assembly LH.
| Proceed to |
|---|
| OK |
| NG |
OK
NG