Be sure to read Precaution thoroughly before servicing (See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT ECU>PRECAUTION).
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81150
1.REMOVE HEADLIGHT ASSEMBLY LH
89907
2.REMOVE HEADLIGHT ECU SUB-ASSEMBLY LH
Prevention of static electricity is required during this procedure.
Use static electricity countermeasures SST (desktop anti-static mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).
If the headlight ECU sub-assembly LH has been dropped , replace it with a new one.
If the headlight ECU sub-assembly LH has been removed, replace the headlight gasket with a new one.
Remove the 3 screws and headlight ECU sub-assembly LH.
Disconnect the connector cover.
Disconnect the 2 connectors.
81134
3.REMOVE HEADLIGHT GASKET
Prevention of static electricity is required during this procedure.
Use static electricity countermeasures SST (desktop anti-static mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).
If the headlight gasket has been removed, replace it with a new one.
Remove the headlight gasket.