Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ECU>PRECAUTION
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81134
1.INSTALL HEADLIGHT GASKET
Prevention of static electricity is required during this procedure.
Use static electricity countermeasures SST (desktop anti-static mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).
Install a new headlight gasket to the headlight ECU sub-assembly LH.
89907
2.INSTALL HEADLIGHT ECU SUB-ASSEMBLY LH
Prevention of static electricity is required during this procedure.
Use static electricity countermeasures SST (desktop anti-static mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).
If the headlight ECU sub-assembly LH has been dropped , replace it with a new one.
Connect the 2 connectors.
Return the connector cover to its original position.
Install the headlight ECU sub-assembly LH with the 3 screws.
81150
3.INSTALL HEADLIGHT ASSEMBLY LH
4.PERFORM REGISTRATION