Home › Drivetrain › AXLE AND DIFFERENTIAL › DIFFERENTIAL SYSTEM (w/ Differential Lock) › from 2017.08
RM27T0E _52 Drivetrain _053705 AXLE AND DIFFERENTIAL _0326415 DIFFERENTIAL SYSTEM(w/ Differential Lock) C

AXLE AND DIFFERENTIAL  DIFFERENTIAL SYSTEM(w/ Differential Lock)  U0416  Invalid Data Received from Vehicle Dynamics Control Module  


DESCRIPTION

This DTC is output if a wheel speed malfunction signal is sent from the skid control ECU (master cylinder solenoid).

DTC No. DTC Detection Condition
1.

Diagnosis Condition

2.

Malfunction Status

3.

Malfunction Time

4.

Other


Trouble Area
U0416
1.

Ignition switch ON (3 seconds elapse after ignition switch is turned to ON)

2.

Wheel speed sensor malfunction signals from skid control ECU are received

3.

0.06 seconds or more (malfunction signal received 1 or more times) when transfer is switching between high and low, when center differential is switching between free and lock, or when rear differential is switching between free and lock

4.

1 trip detection logic


·

CAN communication system

·

Vehicle stability control system (w/ VSC (for Hydraulic Brake Booster))



PROCEDURE

1.RECONFIRM DTC

b.

Check if the same DTC is output (See page Drivetrain>AXLE AND DIFFERENTIAL>DIFFERENTIAL SYSTEM (w/ Differential Lock)>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC U0122 and U0416 are output A
Only DTC U0416 is output (w/ VSC (for Hydraulic Brake Booster)) B
DTC is not output C



A

B

C