Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
84010A
1.REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY
55436A
2.REMOVE INSTRUMENT PANEL FINISH PANEL END LH
55449C
3.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
55435A
4.REMOVE INSTRUMENT PANEL FINISH PANEL END RH
55448A
5.REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION
Use the same procedure described for the No. 2 instrument panel finish panel cushion.
58805E
6.REMOVE LOWER CONSOLE PANEL SUB-ASSEMBLY
Detach the 10 clips and remove the lower console panel sub-assembly.
Disconnect each connector.
55606
7.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
58816B
8.REMOVE CONSOLE BOX INSERT
55607
9.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
58817A
10.REMOVE FRONT NO. 2 CONSOLE BOX INSERT
33504F
11.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
Twist the shift lever knob in the direction indicated by the arrow and remove it.
12.REMOVE CONSOLE PANEL SUB-ASSEMBLY
|
Protective Tape |
Put protective tape around the console panel.
Using a moulding remover, detach the 8 clips and 2 claws.
Disconnect each connector and remove the console panel.
55084E
13.REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY (w/ Cool Box)
58861B
14.REMOVE NO. 1 CONSOLE BOX DUCT (for Single Air Conditioning System)
58903A
15.REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY
58910C
16.REMOVE REAR CONSOLE BOX ASSEMBLY
Remove the 2 screws, clip and 5 bolts.
Disconnect each connector and remove the rear console box.