Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
58910C
1.INSTALL REAR CONSOLE BOX ASSEMBLY
Connect each connector.
Install the rear console box assembly with the 2 screws, clip and 5 bolts.
58903A
2.INSTALL REAR CONSOLE END PANEL SUB-ASSEMBLY
58861B
3.INSTALL NO. 1 CONSOLE BOX DUCT (for Single Air Conditioning System)
55084E
4.INSTALL NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY (w/ Cool Box)
5.INSTALL CONSOLE PANEL SUB-ASSEMBLY
Connect each connector.
Attach the 8 clips and 2 claws to install the console panel sub-assembly.
33504F
6.INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
Install the shift lever knob and twist it in the direction indicated by the arrow.
58817A
7.INSTALL FRONT NO. 2 CONSOLE BOX INSERT
55607
8.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
58816B
9.INSTALL CONSOLE BOX INSERT
55606
10.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
58805E
11.INSTALL LOWER CONSOLE PANEL SUB-ASSEMBLY
Connect each connector.
Attach the 10 clips to install the lower console panel sub-assembly.
55449C
12.INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
55436A
13.INSTALL INSTRUMENT PANEL FINISH PANEL END LH
55448A
14.INSTALL NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION
Use the same procedure described for the No. 2 instrument panel finish panel cushion.
55435A
15.INSTALL INSTRUMENT PANEL FINISH PANEL END RH
84010A
16.INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY