Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
63341
1.REMOVE NO. 1 ROOF SILENCER PAD
w/o Sliding Roof:
Remove the 3 No. 1 roof silencer pads.
w/ Sliding Roof:
Remove the No. 1 roof silencer pad.
63342
2.REMOVE NO. 2 ROOF SILENCER PAD (w/o Sliding Roof)
Remove the No. 2 roof silencer pad.
63344
3.REMOVE NO. 4 ROOF SILENCER PAD (w/o Sliding Roof)
Remove the No. 4 roof silencer pad.
81340J
4.REMOVE VANITY LIGHT ASSEMBLY LH
81340H
5.REMOVE VANITY LIGHT ASSEMBLY RH
Use the same procedure described for the LH side.
82171
6.REMOVE NO. 1 ROOF WIRE
Turn the visor connectors approximately 90° clockwise and remove them from the roof headlining assembly.
Detach each clamp and remove the No. 1 roof wire.
Remove any butyl tape remaining on the roof headlining assembly.
| *A | w/o Sliding Roof | *B | w/ Sliding Roof |
| *C | w/ Rain Sensor, for LHD | *D | w/ EC Mirror |
| *E | w/ Rain Sensor, for RHD | *F | w/ Pre-crash Safety System |
| *G | w/ Pre-crash Safety System, w/ Camera Heater | - | - |
| *a | Visor Connector | - | - |
86101
7.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY