The skid control ECU (master cylinder solenoid) inputs stop light switch signals and the condition of brake operation.
The skid control ECU (master cylinder solenoid) has an open detection circuit, which outputs this DTC when detecting an open in the stop light input line or the ground line of the stop light circuit with the stop light switch off (brake pedal not depressed).
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1425 | When the IG1 terminal voltage is between 9.5 and 17.4 V and the skid control ECU STPO terminal output is off, an open in the STP terminal circuit continues for 3 seconds or more. | ·
STP terminal circuit ·
Stop light switch assembly ·
Stop light switch assembly circuit ·
Skid control ECU (Master cylinder solenoid) |
When replacing the skid control ECU (master cylinder solenoid), perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>CALIBRATION).
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Stop Light SW | Stop light switch / ON or OFF | ON: Brake pedal depressed
OFF: Brake pedal released |
- |
Check that the stop light switch display observed on the GTS changes according to brake pedal operation.
The GTS displays ON or OFF according to brake pedal operation.
OK
NG
Start the engine.
Depress the brake pedal several times to test the stop light circuit.
Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output (for LHD) | B |
| DTC is output (for RHD) | C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C
Remove the stop light switch assembly (See pageVehicle Exterior>LIGHTING (EXT)>STOP LIGHT CONTROL RELAY>REMOVAL).
Inspect the stop light switch assembly (See pageVehicle Exterior>LIGHTING (EXT)>STOP LIGHT CONTROL RELAY>INSPECTION).
The stop light switch assembly is normal.
OK
NG
Disconnect the A7 skid control ECU (master cylinder solenoid) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A7-7 (STP) - Body ground | Brake pedal depressed | 8 to 14 V |
| Brake pedal released | Below 1.5 V |
| *a | Front view of wire harness connector
(to Skid Control ECU (Master Cylinder Solenoid)) |
OK
NG
Start the engine.
Depress the brake pedal several times to test the stop light circuit.
Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output (for LHD) | B |
| DTC is output (for RHD) | C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C