Home › Suspension › SUSPENSION CONTROL › ABSORBER CONTROL SWITCH › 2017.08–2020.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260884 ABSORBER CONTROL SWITCH G

SUSPENSION CONTROL  ABSORBER CONTROL SWITCH  INSPECTION  


PROCEDURE

Hide 89299 1.INSPECT ABSORBER CONTROL SWITCH (SUSPENSION CONTROL SWITCH)

a.
C383878C01
2.542,0.219 2.115,0.219 2.115,0.219 1.917,1 true 0.917,1.594 1.635,1.594 1.635,1.594 1.74,1.323 true 1.417,0.99 1.198,0.219 1.198,0.219 1,0.219 true 0.104,0.083 0.417,0.281 0.313,0.198 10 false *a 2.615,0.146 3.083,0.365 0.469,0.219 10 true COMF 0.5,1.521 1.063,1.76 0.563,0.24 10 true SPORT 0.844,0.135 1,0.333 0.156,0.198 10 false E
*a Component without harness connected
(Absorber Control Switch (Suspension Control Switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
2 (COMF) - 5 (GND) COMFORT position Below 1 Ω
Normal position 10 kΩ or higher
8 (SPORT) - 5 (GND) SPORT position Below 1 Ω
Normal position 10 kΩ or higher


If the result is not as specified, replace the absorber control switch (suspension control switch).


b.
C383878C02
2.094,1.01 2.333,0.198 2.333,0.198 2.729,0.198 true 0.792,1.521 1.135,1.521 1.135,1.521 1.396,1.323 true 0.094,0.083 0.406,0.281 0.313,0.198 10 false *a 2.802,0.115 3.25,0.344 0.448,0.229 10 false ILL+ 0.521,1.438 0.854,1.635 0.333,0.198 10 false ILL-
*a Component without harness connected
(Absorber Control Switch (Suspension Control Switch))


Apply battery voltage to the connector and check the illumination conditions.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 1 (ILL+)
Battery negative (-) → 10 (ILL-)
Illuminates


If the result is not as specified, replace the absorber control switch (suspension control switch).