Home › Suspension › SUSPENSION CONTROL › HEIGHT CONTROL OFF SWITCH › from 2017.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260882 HEIGHT CONTROL OFF SWITCH G

SUSPENSION CONTROL  HEIGHT CONTROL OFF SWITCH  INSPECTION  


PROCEDURE

Hide 84970 1.INSPECT COMBINATION SWITCH ASSEMBLY (HEIGHT CONTROL OFF SWITCH)

a.
C281308C08
2.042,0.927 2.406,0.208 2.406,0.208 2.677,0.208 true 0.74,1.26 1.031,1.792 1.031,1.792 1.313,1.792 true 2.75,0.104 2.99,0.292 0.24,0.188 10 false N 1.375,1.688 1.552,1.875 0.177,0.188 10 false E 0.083,0.094 0.323,0.281 0.24,0.188 10 false *a
*a Component without harness connected
(Combination Switch Assembly (Height Control OFF Switch))


Measure the resistance according to the values in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
5 (N) - 24 (E) Height control OFF switch pressed Below 1 Ω
Height control OFF switch not pressed 10 kΩ or higher


If the result is not as specified, replace the combination switch assembly (height control OFF switch).


b.
C281308C11
2.833,1.917 2.667,1.917 2.667,1.917 2.667,1.229 true 0.75,0.948 0.75,0.25 0.75,0.25 1,0.25 true 0.104,0.115 0.417,0.313 0.313,0.198 10 false *a 2.917,1.833 3.25,2.042 0.333,0.208 10 false ILL+ 1.083,0.167 1.417,0.365 0.333,0.198 10 false ILL-
*a Component without harness connected
(Combination Switch Assembly (Height Control OFF Switch))


Apply battery voltage to the connector and check the illumination conditions.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 13 (ILL+)
Battery negative (-) → 12 (ILL-)
Illuminates


If the result is not as specified, replace the combination switch assembly (height control OFF switch).