Home › Suspension › SUSPENSION CONTROL › HEIGHT CONTROL SWITCH › from 2017.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260883 HEIGHT CONTROL SWITCH G

SUSPENSION CONTROL  HEIGHT CONTROL SWITCH  INSPECTION  


PROCEDURE

Hide 84970 1.INSPECT COMBINATION SWITCH ASSEMBLY (HEIGHT CONTROL SWITCH)

a.
C281308C09
1.844,0.917 2.167,0.219 2.167,0.219 2.344,0.219 true 1.563,0.917 1.302,0.219 1.302,0.219 1.146,0.219 true 0.74,1.26 1,1.833 1,1.833 1.156,1.833 true 2.396,0.135 2.646,0.323 0.25,0.188 10 false HI 0.885,0.146 1.115,0.333 0.229,0.188 10 false LO 1.219,1.74 1.396,1.927 0.177,0.188 10 false E 0.052,0 0.323,0.188 0.271,0.188 10 false *a
*a Component without harness connected
(Combination Switch Assembly (Height Control Switch))


Measure the resistance according to the values in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
7 (LO) - 24 (E) "Down" pressed Below 1 Ω
"Up" pressed 10 kΩ or higher
6 (HI) - 24 (E) "Down" pressed 10 kΩ or higher
"Up" pressed Below 1 Ω


If the result is not as specified, replace the combination switch assembly (height control switch).


b.
C281308C11
2.833,1.917 2.667,1.917 2.667,1.917 2.667,1.229 true 0.75,0.948 0.75,0.25 0.75,0.25 1,0.25 true 0.104,0.115 0.417,0.313 0.313,0.198 10 false *a 2.917,1.833 3.25,2.042 0.333,0.208 10 false ILL+ 1.083,0.167 1.417,0.365 0.333,0.198 10 false ILL-
*a Component without harness connected
(Combination Switch Assembly (Height Control Switch))


Apply battery voltage to the connector and check the illumination conditions.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 13 (ILL+)
Battery negative (-) → 12 (ILL-)
Illuminates


If the result is not as specified, replace the combination switch assembly (height control switch).