Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering wheel (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE STEERING PAD
45116
4.REMOVE NO. 1 STEERING WHEEL ORNAMENT
Remove the 2 screws.
Detach the 2 claws and 2 guide pins, remove the No. 1 steering wheel ornament.
45117
5.REMOVE NO. 2 STEERING WHEEL ORNAMENT
Refer to "Remove No. 1 Steering Wheel Ornament".
84250A
6.REMOVE STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)
Remove the 4 screws.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
While pushing the steering pad switch assembly in the direction shown by the arrow (1) in the illustration to disengage the claw, pull the steering pad switch assembly in the direction shown by the arrow (2) in the illustration to disengage the guide pin.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
While pushing the steering pad switch assembly in the direction shown by the arrow (1) in the illustration to disengage the claw, pull the steering pad switch assembly in the direction shown by the arrow (2) in the illustration to disengage the guide pin.
Remove the part from the steering wheel sub-assembly.
Use the same procedure for both sides.
84247A
7.REMOVE STEERING PAD SWITCH LH (w/ Steering Pad Switch)
Refer to "Remove Steering Pad Switch Assembly".
84632
8.REMOVE CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)
45100
9.REMOVE STEERING WHEEL ASSEMBLY
Remove the steering wheel set nut.
Put matchmarks on the steering wheel and main shaft.
| *a | Matchmark |
| *b | Hold |
| *c | Turn |
Using SST, remove the steering wheel assembly.
45713A
10.REMOVE STEERING SHAKE DAMPER (w/ Steering Shake Damper)
Remove the 2 screws and remove the steering shake damper.
45184
11.REMOVE STEERING WHEEL BOSS LOWER COVER (w/o Steering Heater)
Detach the 6 claws remove the steering wheel boss lower cover.