This DTC is stored when LIN communication between the certification ECU and steering lock actuator assembly (steering lock ECU) stops for 10 seconds or more.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2786 | LIN communication between the certification ECU and steering lock ECU stops for 10 seconds or more. | ·
Steering lock actuator assembly (steering lock ECU) ·
Certification ECU ·
Harness or connector |
When using the intelligent tester with the ignition switch off to troubleshoot:
Connect the intelligent tester to the vehicle and turn a courtesy light switch on and off at 1.5 second intervals until communication between the intelligent tester and vehicle begins.
Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.
When communication between the steering lock ECU and certification ECU stops, DTC B2785 is also stored.
Clear the DTCs (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR).
NEXT
Check for DTCs (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR).
DTC B2786 is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Disconnect the G215 certification ECU connector.
Disconnect the G35 steering lock actuator assembly (steering lock ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G215-6 (LIN) - G35-5 (LIN) | Always | Below 1 Ω |
| G215-6 (LIN) or G35-5 (LIN) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the G35 steering lock actuator assembly (steering lock ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G35-1 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G35-6 (IG2) - Body ground | Ignition switch ON | 11 to 14 V |
| G35-7 (B) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector
(to Steering Lock Actuator [Steering Lock ECU]) |
OK
NG
Temporarily replace the steering lock actuator assembly (steering lock ECU) with a new one.
for Manual Tilt and Manual Telescopic Steering Column: See page Steering>STEERING COLUMN>STEERING COLUMN ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column)>DISASSEMBLY
for Power Tilt and Power Telescopic Steering Column: See page Steering>STEERING COLUMN>STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column)>DISASSEMBLY
NEXT
Clear the DTCs (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR).
NEXT
Check for DTCs (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR).
DTC B2786 is not output.
OK
NG