When the ignition switch is turned to ON, battery voltage is applied to terminal IG2 of the TCM.
Refer to DTC P0560 (See page Drivetrain>A750F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM (for 1KD-FTV)>P0560).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the G69 TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G69-1 (E1) - Body ground | Always | Below 1 Ω |
| *a | Rear view of wire harness connector
(to TCM) |
OK
NG
Disconnect the No. 1 integration relay 1V connector.
Disconnect the G70 TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1V-8 - G70-6 (IG2) | Always | Below 1 Ω |
| 1V-8 or G70-6 (IG2) - Body ground | Always | 10 kΩ or higher |
OK
NG