1.REMOVE REAR BUMPER COVER
89348D
2.REMOVE ULTRASONIC SENSOR CLIP
Use the same procedure to remove the ultrasonic sensor clip on the other side.
Detach the claws and remove the ultrasonic sensor clip.
89342
3.REMOVE REAR CORNER ULTRASONIC SENSOR
Use the same procedure to remove the rear corner ultrasonic sensor on the other side.
Disconnect the connector.
Detach the 2 claws and remove the rear corner ultrasonic sensor.
Before removing the ultrasonic sensor, make sure to mark the ultrasonic sensor and front bumper cover so that each ultrasonic sensor can be returned to its original position.
89348R
4.REMOVE REAR CORNER ULTRASONIC SENSOR RETAINER
Use the same procedure to remove the rear corner ultrasonic sensor retainer on the other side.
Using a heat light, heat the rear bumper cover.
| Item | Temperature |
|---|---|
| Rear Bumper Cover | 40 to 60°C (104 to 140°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the rear bumper cover excessively.
Remove the rear corner ultrasonic sensor retainer.
89342A
5.REMOVE REAR CENTER ULTRASONIC SENSOR
Use the same procedure described for the rear corner ultrasonic sensor.
89348S
6.REMOVE REAR CENTER ULTRASONIC SENSOR RETAINER
Use the same procedure described for the rear corner ultrasonic sensor retainer.