Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
87940
1.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH
87961
2.REMOVE OUTER REAR VIEW MIRROR GLASS
87945
3.REMOVE OUTER MIRROR COVER LH
81740
4.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH
86790C
5.REMOVE SIDE TELEVISION CAMERA ASSEMBLY
| *a | Tape |
| *b | Clamp |
Remove the tape and detach the clamp.
Remove the screw, detach the 4 claws and disconnect the outer rear view mirror gasket LH.
It is not necessary to completely remove the outer rear view mirror gasket LH. Slightly move the outer rear view mirror gasket LH so that the lower mirror cover can be removed in a later step.
Remove the lower mirror cover.
|
Protective Tape |
Put protective tape around the lower mirror cover.
The claws of the mirror will be detached in the order shown in the illustration in the following steps.
|
Protective Tape |
Using a screwdriver, detach the claw.
Tape the screwdriver tip before use.
|
Protective Tape |
Using a screwdriver, detach the claw.
Tape the screwdriver tip before use.
|
Protective Tape |
Using a screwdriver, detach the claw to create a space between the lower mirror cover and mirror body as shown in the illustration.
Tape the screwdriver tip before use.
|
Protective Tape |
Insert a screwdriver as shown in the illustration.
Tape the screwdriver tip before use.
|
Protective Tape |
Detach the claw to create a space between the lower mirror cover and mirror body as shown in the illustration.
Tape the screwdriver tip before use.
While moving the lower mirror cover back and forth in the directions of the arrows in the illustration, detach the 2 claws and remove the lower mirror cover.
Using a T25 "TORX" socket wrench, remove the 3 "TORX" screws.
Remove the 5 screws and outer mirror body.
| *a | Guide |
Detach the guide and remove the cover body.
Be careful as the guide shown in the part of the illustration is easily damaged.
|
Protective Tape |
Using a screwdriver, disconnect the connector.
When disconnecting the connector, be careful not to damage it.
Tape the screwdriver tip before use.
Detach the clamp.
Remove the 2 screws and side television camera assembly.