Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › 2017.08–2020.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0260747 CRUISE CONTROL SYSTEM C

CRUISE CONTROL  CRUISE CONTROL SYSTEM  P0500  Vehicle Speed Sensor Circuit  


DESCRIPTION

The speed sensor installed on the wheels outputs wheel speed pulse signals which are then converted to vehicle speed pulse signals by the skid control ECU. These pulse signals are then output to the combination meter assembly as vehicle speed signals and then input to the ECU.

DTC No. Detection Item DTC Detection Condition Trouble Area
P0500 Vehicle Speed Sensor Circuit The vehicle speed signal from the vehicle speed sensor is cut for 0.14 seconds or more while the cruise control is in operation
·

Vehicle stability control system

·

Meter / gauge system

·

ECM



CAUTION / NOTICE / HINT

NOTICE:

This DTC may be output by the SFI system at the same time. In that case, perform troubleshooting for the SFI system first.


PROCEDURE

1.CHECK FOR DTCs
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.



e.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.


i.

Drive the vehicle for more than 10 seconds when the engine coolant temperature is more than 20°C (68°F).




Result:
Result Proceed to
DTC P0500 is not output A
DTC P0500 is output B



A

B