Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › MULTI-TERRAIN MONITOR SYSTEM › 2017.08–2020.08
RM27T0E _56 Audio / Visual / Telematics _053722 PARK ASSIST / MONITORING _0328431 MULTI-TERRAIN MONITOR SYSTEM C

PARK ASSIST / MONITORING  MULTI-TERRAIN MONITOR SYSTEM  C164D  Wheel Speed Sensor Malfunction  


DESCRIPTION

This DTC is stored when the parking assist ECU receives a wheel speed sensor abnormality signal from the vehicle stability control system via CAN communication.

DTC Code DTC Detection Condition Trouble Area
C164D Wheel speed sensor malfunction. Vehicle stability control system

CAUTION / NOTICE / HINT

NOTICE:
·

When "!" mark is displayed on the navigation receiver assembly*1 or radio and display receiver assembly*2 after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>INITIALIZATION

*1: for Navigation Receiver Type

*2: for Radio and Display Type


·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the multi-terrain monitor system may be needed.

(See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION)

·

The multi-terrain monitor system troubleshooting procedure is based on the premise that the vehicle stability control system is operating normally. Check the vehicle stability control system first before troubleshooting the multi-terrain monitor system.

for Vacuum Brake Booster

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)>HOW TO PROCEED WITH TROUBLESHOOTING

for Hydraulic Brake Booster

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>HOW TO PROCEED WITH TROUBLESHOOTING